Installation Manual
12
Making changes to Installer Setup and performing Installer Test
Mounting outdoor and indoor sensors
Follow these steps to set system options after initial installation.
NOTE: Use a USB device to save set up time. See page 14.
1 Touch Menu.
2 Select Installer Options.
3 Enter password (date code)
and touch Done.
4 Select Create Setup or Installer Test.
5 Follow prompts on the screen to
select the desired setup options
or to perform an equipment test.
Installer Opons
Done
Mounting an outdoor sensor
1 Mount the sensor on a vertical
exterior wall, at least 6 inches below
any overhang. Choose a location
protected from direct sunlight.
2 Place sensor securely in bracket,
facing away from wall.