Installation Manual

Using a USB device for setup, data logs and software upgrades

Use a USB device to save set up time by loading Installer Setup settings, Dealer

Information, Holiday Schedules, and Custom Reminders to multiple thermostats.

For troubleshooting help, you can save the thermostat Data Logs (Alerts Log, User

Interactions Log and Performance Logs) to a USB device - then view them on your

computer. Also use the USB device to upgrade the thermostat software.

• Visit http://thermostatsetup.honeywell.com to enter your dealer

information and contractor logo or load new thermostat software.

• After setup is complete, save Installer Setup, Holiday Schedules, and

Custom Reminders to a USB device.

To use the USB device in the thermostat:

1 Slide USB device into the bottom of

thermostat.

2 Select the item to load or save.

3 Follow the prompts on the screen for the

item you selected.

• To add information from the USB

device to the thermostat, select

Load into Thermostat.

• To put thermostat information on

the USB device, select Save to USB.

When you replace a thermostat, you must reset the RedLINK accessories be-

fore connecting them to the new thermostat. Follow the instructions below.

At the Portable Comfort Control:

Press and hold the blank space (or arrow) in the lower right

corner of the screen until the display changes (hold for about 4

seconds). Press REMOVE, then YES to disconnect the old ther-

mostats. To reconnect the thermostat, go to Step 4.3.

At the Indoor Sensor, RedLINK Internet Gateway, Entry/Exit

Remote, VentFilter Boost Remote or TrueSteam Wireless

Adapter:

Press and hold the CONNECT button on the accessory until the

status light glows amber (hold for about 10 seconds). To recon-

nect the thermostat, go to Step 4.3.

At the Equipment Interface Module (EIM):

Press and hold the CONNECT button on the EIM until the CON

NECTED LED glows amber (hold for about 10 seconds). Follow

the prompts on the screen to connect the new thermostat to

the EIM. To reconnect the thermostat, go to Step 4.2.

Load Installer Setup

into Thermostat

To replace a thermostat

Press and hold

Portable Comfort

Control