Installation Manual

8
4
Performing initial setup
Initial setup options define the type of system you are installing:
• Residential or commercial
• Non-zoned or zoned
• Used with or without an Equipment Interface Module (THM5421)
• Used with or without the TrueZONE Wireless Adapter (THM4000)
4.2 Link the thermostat to the
equipment interface module.
4.2a Press and quickly release the
CONNECT button on the EIM.
Make sure the “Connected” light
is flashing green.
NOTE: If the “Connected” light does
NOT flash green, another system
may be in the listening mode. Please
exit the listening mode at the other
system and then try again.
• Green Flashing: In Listening
Mode - system is ready to add
RedLINK devices.
• Green Steady: RedLINK devices are
communicating.
• Red: RedLINK device(s) are NOT
communicating. Check EIM and
RedLINK devices.
4.2b While the “Connected” light is
flashing green on the EIM, press
Next on the thermostat. After
a short delay, the screen will
display Device Connected.
4.1 Follow prompts on the screen to
select appropriate options.
NOTE: If you are connecting
the thermostat to the TrueZONE
Wireless Adapter (THM4000), refer
to the TrueZONE instructions to
link the thermostat and RedLINK
accessories. Then go to step 4.5.
Next
CONNECT
CONNECTED
Next
Next