Redesigned Prestige IAQ Owners Manual

69-2740—01 12
Remote setback (commercial use)
During Occupied program periods, an occupancy sensor directs the thermostat
to go to REMOTE SETBACK settings when the room is empty. If someone is in
the room, it uses the Occupied program period settings. The thermostat ignores
the occupancy sensor during Unoccupied program periods.
If the thermostat is set up to be non-programmable, the sensor directs the
thermostat to go to REMOTE SETBACK settings when the room is empty. If
someone is in the room, then it follows the settings set by the user.
Depending on how your thermostat was installed, it may delay for up to 30
minutes before switching to REMOTE SETBACK settings. This delay allows the
room to stay comfortable if the room is unoccupied for only a short time.
Adjusting humidification settings
1 Touch MENU and select Humidification.
2 Select Auto.
3 Move the slider bar to select humidity level.
4 Touch More Settings if frost or condensation
appears on the windows. Use a lower
number to prevent frost or condensation.
Use a higher number if indoor air is too dry.
Window Protection limits the amount of
humidity to prevent frost or condensation
on windows. See notes below.
5 Touch Done to save your settings. Touch
Cancel to ignore changes.
NOTE: The thermostat will not run the
humidifier when the indoor humidity
has reached the “Window Limit” that is
displayed on the screen.
NOTE: Window Protection is available only
if an outdoor air sensor is installed.
MENU
Humidificaon
More
Sengs