Installation Guide

3 / 27 HONG KONG KONING INDUSTRIAL LIMITED
Tel:[phone]
E-mail:[e-mail]
W1000 INSTALLATION GUIDE
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
ISED RSS Warning/ISED RF Exposure Statement
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator& your body.This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter. Le rayonnement de la classe b
repecte ISED fixaient un environnement non contrôlés.Installation et mise en œuvre de ce matériel devrait avec
échangeur distance minimale entre 20 cm ton corps.Lanceurs ou ne peuvent pas coexister cette antenne ou capteurs
avec d’autres.
Notice: When this device operating in the 1710-1755Mhz band, the maximum antenna should be fixed height of 10
meters above ground. To meet FCC EIRP limit, the antenna used with amplifier must be connected by a cable with a
minimum signal loss such that the combination of the antenna gain and cable loss should not exceed 3Db.