User's Manual

H8951

NA1

3G/4G Router User

Manual

Parameter Details Option

Manual input

Format1: A.B.C.D/Mask

Port The network interface of QOS Value area: 1-65535

You can not configure the

port, if not the configuration

represents all ports

Rate

Transmission rate of the network

address settings

Value area：1~65535

Units：Kbps

Ceil Rate

In ensuring the basic rate and the

spare bandwidth, the maximum

bandwidth of the network address

of the communication can be

obtained with higher priority will be

given priority redundant bandwidth

Value area：1~65535

Units：Kbps

Priority Set the precedence of the rules

Value area：[1,30]

Step 4 Single click “save” icon to QOS setting.

QoS is mainly used to allocate the average bandwidth for the users which access Internet through the

router, or assigned specific users with more bandwidth. If the router is connected with two subnets:

192.168.8.1/24 and 192.168.9.1/24, the router QOS can control the rate of these two subnets; If the

router's bandwidth is relatively well-off, the router can adjust the bandwidth based on priority and

redundancy of two subnets, that is, the router meets the high priority redundancy bandwidth firstly, then

meets the low priority subnet redundancy bandwidth.

---END

5.5.5 Dynamic Routing (Optional)

RIP configuration

RIP protocol (Routing Information Protocol) is the most widely IGP (Interior Gateway

Protocol), it was designed for the same technology used in small networks, and therefore

adapt to most of the campus network and used in a continuous regional networks that the

rate change is not big, H8951-NA Cellular Wi-Fi Router supports RIP v2 protocol. For more

complex environments, generally do not use the RIP protocol.

Step 1 Log-on WEB GUI of H8951-NA Cellular Wi-Fi Router.

Step 2 Click “Forward > RIP” to open “RIP” tab, as Figure 5-53.