Specification Sheet

1/2

ASSEMBLY INSTRUCTION

Item# 1610-75906-WH Bunching Display Cabinet

*** Caution: Please read all instructions carefully before starting the assembly process.

Please note this cabinet can be used alone with can light on by a touch dimmer. Also,

when two or more are bunched together, you can control all can lights by touching one

dimmer.

Assembly Steps:

1. When each piece of cabinet is used alone, attach male connector of the power switch (A) to a

wall plug. (See Diagram 1)

2. Touch dimmer is at the inside of right post.

3. If you want to bunch two or more cabinets together, place them all side by side in a desired

Diagram 1

Diagram 2

PAGE 1
ASSEMBLY INSTRUCTION Item# 1610-75906-WH Bunching Display Cabinet *** Caution: Please read all instructions carefully before starting the assembly process. Please note this cabinet can be used alone with can light on by a touch dimmer. Also, when two or more are bunched together, you can control all can lights by touching one dimmer. Diagram 1 Diagram 2 Assembly Steps: 1. When each piece of cabinet is used alone, attach male connector of the power switch (A) to a wall plug. (See Diagram 1) 2.
PAGE 2
location. 4. Leave male connector of the can light (C) and female connector of power switch (B) for the first cabinet (#1) as it is. Keep male connector of the can light (C) and female connector of power switch (B) off for the rest cabinets (#2, #3, and so on). (See Diagram 2) Diagram 3 5. Connect female connector of the can light (D) (#1 cabinet) with male connector of power wire (E), then have female connector of power wire (F) connected to male connector of the can light (C) (the #2 cabinet).