Assembly Instructions

1/2

ASSEMBLY INSTRUCTION

Item#: 1618-30220-DKW Deconstructed Tilt Swivel Chair

*** Please ensure you have all parts indicated below prior to assembly.

This item should be assembled on a flat, soft surface to prevent from scratching the

finish while assembling.

Diagram 1 Diagram 2

1. Insert the Pneumatic Cylinder into the base, this is

a taper fit and no mechanical fastening is

required.(See Diagram 1)

2. Put slip sleeve onto the pneumatic cylinder.

(See Diagram 2)

Note: Casters (H) are removable.

3. Place Cylinder cover over the cylinder

(see Diagram 3)

Diagram 3

PAGE 1
ASSEMBLY INSTRUCTION Item#: 1618-30220-DKW Deconstructed Tilt Swivel Chair *** Please ensure you have all parts indicated below prior to assembly. This item should be assembled on a flat, soft surface to prevent from scratching the finish while assembling. 1. Insert the Pneumatic Cylinder into the base, this is a taper fit and no mechanical fastening is required.(See Diagram 1) 2. Put slip sleeve onto the pneumatic cylinder. (See Diagram 2) Note: Casters (H) are removable. H Diagram 1 Diagram 2 3.
PAGE 2
4. Use the Allen Wrench (C) with 4 bolts (D), 4 lock washers (E), 4 Flat Washers (F), attach the ergonomic mechanism to the bottom of the seat. (See Diagram 4) Please note the correct direction to place the tilting mechanism, follow the left diagram. Diagram 4 5. Place the chair body onto the Cylinder. No mechanical fastening is necessary because this is a taper fit. Now sit in the chair. This will firmly secure the taper fit.