Assembly Instructions

1/2

ASSEMBLY INSTRUCTION

Item#:1618-75019-DKW Upholstered Dining Bench

** Please make sure you have all parts indicated below prior to assembly.

Assembly Steps:

Please follow numbers on one chair and letters on the other chair during assembly.

1. Place chair back on a clean surface.

2. Tighten back frame rail to chair back legs (G) and assemble back legs (G) to the corner blocks of

seat frame(I) by using 4 bolts (E), 4 lock washers (C) and 4 flat washers (D).

3. Assemble front legs (F) to corner blocks of seat frame (I), using 4 bolts (E), 4 lock washers (C) and

4 flat washers (D).

4. Screw front and back center leg(H) on center rail using 4 bolt (B), 4 lock washer (C) and 4 flat

washer (D).

5. Make sure the chair is level and then tighten all bolts completely by using Allen wrench (A).

6. Turn the chair upright. Level the chair following the “chair leveling instruction” as below.

Diagram 1

PAGE 1
ASSEMBLY INSTRUCTION Item#:1618-75019-DKW Upholstered Dining Bench ** Please make sure you have all parts indicated below prior to assembly. Assembly Steps: Diagram 1 Please follow numbers on one chair and letters on the other chair during assembly. 1. Place chair back on a clean surface. 2. Tighten back frame rail to chair back legs (G) and assemble back legs (G) to the corner blocks of seat frame(I) by using 4 bolts (E), 4 lock washers (C) and 4 flat washers (D). 3.
PAGE 2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE CHAIRS CHAIR LEVELING INSTRUCTION SUPPLEMENT Chair leveling procedures: To make the assembly process easy and efficient, please read the entire instruction sheet prior to assembling the chair. Make sure all hardware listed is included. To properly assemble the chair, none of the bolts should be fully tightened until all components are attached to the chair. This will allow an opportunity to level the chair and prevent any unnecessary “rocking”. 1.