Installation & Assembly

ASSEMBLY INSTRUCTION
ITEM# 5820-90015-84 One-Drawer Nightstand
**
Please make sure you have all parts indicated below prior to assembly.
Note :1.This table can be used as bedside height and chairside height.
2.The PE block and drawer front are in the opposite direction when assemble them.
Assembly steps:
1. Put nightstand top upside down on a soft surface to prevent it from being scratched
2. Attach legs (F) to nightstand top by using bolts (E),lock washers (B), flat washers (C),and
tighten all with allen wrench (D) in clockwise direction. Well place bottom frame (G) onto legs
(F) to make sure all pre-drilled holes are in alignment , use bolts (A),lock washers (B), flat
washers (C) and tighten all with allen wrench (D) in clockwise direction (See diagram 1).
3. Turn nightstand upright.
4.Please use the long legs to assembly them if want to use this table as bedside table
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.
Diagram 1