User Manual

11
HOSE: How to Clean
4.11
A
CAUTION
! !
To reduce the risk of injury from moving parts, Unplug before servicing.
4.11 To remove Hose for tool use or for maintenance, press the Hose Release
Button (A) and pull Hose end out.
Clear away debris or obstructions from Hose. Do not use sharp objects to clean
out hose as they can cause damage. To lock back into place, push Hose into
Hose Tube until you hear a click.
Actual model may vary from images shown.
4.16 With lettering on outside of belt, slide new belt
over motor shaft (metal rod) (E).
Push other end of belt through belt guide (F), then
slip around area of brushroll without bristles (G).
With belt in place, pull and slide brushroll into nozzle
making sure that the brushroll end caps are in the
correct orientation.
4.16
E
G
BELT
The belt is located under the bottom plate of the
vacuum and should be checked from time to time
to be sure it is in good condition.
When To Replace
How To Replace
4.12 Turn vacuum over so bottom side is facing up.
Rotate red upper latch (A) counter clockwise.
4.13 Slide red lower latch (B) to the unlock position.
4.14 Lift off bottom plate.
4.15 Remove used belt from brushroll (C) then from
motor shaft (metal rod) (D) and discard.
Replace belt if it is stretched, cut or broken.
To check the belt, refer to Fig. 4.12 - 4.14.
4.14
C
D
4.15
4.12
4.13
A
B
F
What to Buy: Belt
Use only genuine HOOVER
®
belts with your
vacuum.
When purchasing a new belt, ask for Stretch Belt
- HOOVER
®
part No. 38528058.
4.17
CAUTION
! !
To reduce the risk of injury from moving parts,
Unplug before servicing.
4.17 Reposition bottom plate, aligning tabs along
front edge of nozzle guard with slots in nozzle.
Rotate back into position. Slide red lower latch to
Lock position, and rotate red upper latch clockwise.
IMPORTANT
Rotate brushroll manually to make sure belt is
not twisted.