INSTRUCTION BOOK DYC 8813B Condenser Tumble Dryer English 2
INDEX Introduction Delivery Information Unpacking the Product Safety Reminders Use Installation The Laundry Environmental Issues Gias Service Installation Electrical Requirements Adjusting the Feet Ventilation Drain Hose : Fitting Instructions Preparing the Load Clothes Preparation Do Not Tumble Dry Energy Saving Sorting the Load Drying Guide Controls and Indicators Selecting the Programme Door and Filter Opening the Door Filter Filter Care Indicator Water Container To Remove the Container Condenser To Remo
INTRODUCTION Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. Keep all documentation in a safe place for future reference or for any future owners.
SAFETY REMINDERS Installation ● Check that the product has no visible signs of damage before use. If damaged do not use and please call GIAS Service. ● Do not use adapters, multiple connectors and/or extensions. ● Never install the dryer against curtains and be sure to prevent items from falling or collecting behind the dryer. ● The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the tumble dryer.
INSTALLATION Electrical Requirements Tumble dryers are supplied to operate at a voltage of 230V, 50 Hz single phase. Check that the supply circuit is rated to at least 13A Electricity can be extremely dangerous. This appliance must be earthed. The socket outlet and the plug on the appliance must be of the same type. Do not use multiple adapters and/or extension leads. The plug should be accessible for disconnection after the appliance has been installed.
DRAIN HOSE : FITTING INSTRUCTIONS To avoid emptying the water container after each drying cycle, the water can be discharged directly to a waste water drain pipe (the same drainage system as household sinks). Water Bye-Laws prohibit connection to a surface water drain. The waste water drain pipe should be located adjacent to the tumble dryer. The kit consists of:1 hose and 1 tap. WARNING! Switch off and remove the tumble dryer plug from the electricity supply before carrying out any work.
PREPARING THE LOAD Before using the tumble dryer for the first time: ● Please read this instruction book thoroughly. ● Remove all items packed inside drum. ● Wipe the inside of the drum and door with a damp cloth to remove any dust which may have settled in transit. Clothes Preparation Make sure that the laundry you are going to dry is suitable for drying in a tumble dryer, as shown by the care symbols on each item. Check that all fastenings are closed and that pockets are empty.
CONTROLS AND INDICATORS Programme Selector Empty Water Indicator Time Selection Button Filter Care Indicator Delay Start Button Program Display Acrylic Synthetic Button Start/Pause Button Anti-Crease Button Control Panel and Indicator Lights Programme Selector – Select the required programme Time Selection Button – Allows the user to change duration of the programme selected by Programme Selector.
SELECTING THE PROGRAMME PROGRAMME DESCRIPTION Bone Dry Store Dry Hang Dry Iron Dry Select the degree of dryness that you require. This range from for bath towels and bathrobes, through for items that will be put away without ironing, to the programme that leaves the laundry suitable for ironing. Relax The programme provides a conditioning and anticrease function.
DOOR and FILTER Opening the Door Pull on handle to open the door. To restart the dryer, close the door and press Start/Pause Button. WARNING! When the tumble dryer is in use the drum and door may be VERY HOT. Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. Filter IMPORTANT: To maintain the efficiency of the dryer check that the fluff filter is clean before each drying cycle. 1.Pull the upwards. filter 2.
CONDENSER Important: Always switch off and remove the plug from the electricity supply before cleaning the condenser. To maintain the efficiency of the dryer regularly check that the condenser is clean. To Remove the Condenser 1.Remove kickplate. OPERATION 1. Open the door and load the drum with laundry. Ensure that garments do not hinder closure of the door. 2. Gently close the door pushing it slowly until you hear the door 'click' shut. the 3.
OPERATION Delay Start Function The Delay Start Function allows the user to delay the start of the drying cycle by 1 to 24 hours. When the function is first selected the display will show a delay of 1 hour, subsequent presses of the button will increase the delay with 1 hour steps. To commence the programme press Start/Pause button and the appliance will complete the drying cycle at the end of this time. The indicator light will flash to indicate that the start delay is in progress.
TROUBLESHOOTING What Might be the Cause of... Defects you can remedy yourself Before calling GIAS Service for technical advice please run through the following checklist. A charge will be made if the machine is found to be working or has been installed incorrectly or used incorrectly. If the problem persists after completing the recommended checks, please call GIAS Service, they may be able to assist you over the telephone. Time display to end could change during drying cycle.
YOUR GUARANTEE For a period of one year from the date of purchase the appliance is covered by a guarantee which allows you to call GIAS Service free of charge. Remember to send off the guarantee certificate for validation within 10 days of the date of purchase. You should retain the receipt issued by the retailer when you purchased the machine to show to the call out engineer, should you need to consult one.
40006436