The Easy tc Use Deep Cleaner with attached tools ENGLISH = pp. 1-15 LIFESPAN » pag. 16-30 FRANGLAIS Review this manual before Owner's Manual operating deep cleaner. Record and Retain This HOOVER deep cleaner is designed for deep cleaning of carpet, and rugs. It can also be used to clean carpeted stairs and upholstery. The model and serial numbers are located on the data label on the back of the deep cleaner handle.
portal nt Safeguards! When using an electrical appliance, always follow basic precautions, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNING: To reduce the risk of fire, electric + Use indoors only. shock, or injury: + Use only on surfaces moistened by the cleaning process or small spills. Do not immerse product. + Connect to a properly grounded outlet only. See “Grounding Instructions”. + De not clean over floor electrical outlets.
Assembling deep cleaner The assembled cleaner will look fiche this drawing Remove clean solution tank {upper tan (Fig, 1), Remove nozzle stared on upper Candle by gently pushing nozzle downward while pivoting it away from the handle at {B), With card hock to back of deep cleaner, push upper handle down onto tower candle. (Fig 4} Push bolts into holes on front of handle (Fig.
sal Crass Cora into card lip on back of handier, Pauli cord tight (Fig, 8) Attach lower hose holder PROJECTIONS With front of deep cleaner resting an floor, place 2 projections on lower hose holder ino 2 holes on back of cleaner (Fig 9).
The nozzle is stored in the area between the cord hooks (Fig. 15) Place brushes of nozzle an top of Tab (A) as shown. Gently push the nozzle downward while pivoting it inch the nozzle hat car {B) Deep cleaner description The asserted deep cleaner will look tke the drawing below, Hand grip Solution trigger: press ta release clean solution. Hose Hose holders: wrap nose around holders for storage. Cord hooks! wrap cord around hooks for storage.
General operation Operate deep cleaner only at voltage specified on data plate on back of cleaner. ON/OFF pedal Plug deep cleaner into a properly grounded outlet.
Brush indicator The trash indicator will spin when the deep cleaner is turned on and the brushes are rotating. if the indicator does not spin and the pattern is visible when the deep cleaner is turned on, the brushes are not rotating. There are three Solution tube fs why the brushes may not be rotating: speed selector set on OFF, (See connected (page 12). 4. Brush ina or Serene diy, To clean screen, turn deep cleaner off and disconnect from electrical outlet. ~\ nh AY SCREEN Remove ole ar Over and wipe off
Replace cap. Rotate cap clockwise until it locks in place. Cap must be locked in place for proper performance and to prevent leaking. Position bottom of tank into unit and press on tank handle © 0 tank into place. Recovery tank {lower tank) The recovery tank gelds the dint solution that is picked up from the carpet When the recovery tank is full, the automatic shut-off” wit engage soe page 6} and the wank must ba emptied How to empty TANK Ted Turn deep cleaner off and disconnect from electrical outlet.
How to use Before you begin cleaning a. Vacuum thoroughly for carpet, use a vacuum lute, Vacuum upholstery with a vacuum cleaner with cleaning ol attachments, Use a crevice tool ta reach into wits and folds. Do not use the ‘Steam Vac’ deep cleaner as a dry vacuum cleaner. b. For upholstery, check cleaning code Use your HOOVER ‘Steam Vac deep cleaner ony if tha upholstery fabric is marked with a “WW {tor “wet” clean} or "S/W" {tor “solvent” or “wet” clean). Do not clean fabric marked “8” clean only).
Ci caning carpet Read “Before you begin cleaning” instructions on page 8. 1 solution tak (Upper tank) according to Instructions on «7 ana 8 or HOOVER Carpetbagging Gargantuan. Usa 5 our Move speed selector to LO for gentle cleaning or Hi for normal cleaning. Dry hands and plug cord into » properly grounded outlet. Do not clean over floor electrical outlets. To avail walking an damp carpet.
With handle in upright position. tit deep cleaner back so that Handle rests on the floor, Lac. netting) in position as shown attachment on front of nozzle with foam strip {under Push ¢ until both ends Attachment against lip while rotating attachment downward snap’ into place. {Note: Some force may be required to rotate and snap attachment inch place.} Return deep cleaner to upright position. Lower handier and replace recovery tank.
Before connecting tube to cleaner, make sure black tabs are extended by pulling tan collar toward tube. Warlords sound solution tbe cer Open road an hood label Connection”. Pres projection inside door stir onto round Press connector collar down firmly to ensure that it is fully connected. When the solution tube is connected to the deep cleaner, the nozzle brushes will automatically be turned off and will not rotate when the deep cleaner is turned on even if the speed selector is in the Hl or LO position.
After using stairfupholstery nozzle Folio the instructions for "Amer cleaning” on page 3. Drain suction hose by muting deep cleaner ON and holding nozzle up for several minutes. DO NOt press rigger. Disconnect deep cleaner from electrical outlet. Disconnect hose and solution tube from deep cleaner. r= ¥ Drain solution tube by placing round end in sink, and raising nozzle above your head.
Cleaning uphold trey and automobile interiors Read “Before you begin cleaning” instructions on page 9. Be sure to check the cleaning code on your upholstery. Use your HOOVER ‘Steam Vac’ deep cleaner only on upholstery marked “W” or “WIS”. Attach hose and solution tube as instructed on pages 11 and 12 Agitator brushes will not rotate while “solution tube” is connected to deep cleaner.
If you have a problem If @ minor problem occurs, it usually can be solved quite easily when the cause is found by using the check st below.
