Manual

B
Press both latches (B) and pull brush
block out. The brushes can be cleaned
under running water.
To replace brushes
Align posts (C) on both ends of brush
assembly with slots (U) in cleaner hous-
ing.
Make sure that the square post (E) also
aligns with the square hole (F). Turn
brushes slightly until post fits easily into
hole.
Press brush firmly to snap into place.
Storage
Before storing:
• Empty solution tank and rinse
thoroughly with Glean water.
• Replace empty solution tank and
turn deep cleaner ON. Squeeze
trigger and push deep cleaner for-
ward and back several times to
expel any solution remaining in the
deep cleaner's system. (Do not use
deep Gleaner on wood floors.)
• Empty recovery tank and rinse
thoroughly with clean water.
Allow brushes and underside of deep
cleaner to air dry thoroughly before
storing deep cleaner on a carpeted or
wood surface.
Do not store deep cleaner with a full
solution tank in place.
If a minor problem occurs, it usually can
be solved quite easily when the cause is
found by using the check list below.
Possible cause
Possible solution
• Not firmly plugged in
• Plug unit in firmly
• No voltage in wall plug
• Check fuse or" breaker
• Blown fuse/tripped breaker
• Replace fuse/reset breaker
• Recovery tank lid not on
correctly
• Make sure lid is firmly in place
• Pump needs to be "primed"(when
using tool)
• See "Before using tool" section, p.ll
Possible cause
Possible solution
• Dirty filter screen on bottom of unit
• Clean screen as shown in Fig. 3-2
• Speed selector on OFF
• Move speed selector to Low or Hi
Lubrication
The motor is equipped with bearings
which contain sufficient lubrication for
the life of the motor. The addition of
lubricant could cause damage. DO not
add lubricant to motor bearings.
Possible cause
Possible solution
• Recovery tank full/automatic
shut off engaged
• Remove and empty recovery tank
• Blockage in tool on end of hose
• Remove tool and clear blockage
• Recovery tank lid not on
correctly
• Make sure lid is on securely
14
Possible cause
Possible solution
• Solution tank not firmly in place
• Make sure tank is securely looked in
position
• Solution tank empty
• Refill tank according to instructions for
surface being cleaned