Manual

i¸ /

With cord hook (B) to back of cleaner, Insert two screws into back of handle

push upper handle down onto cleaner, as shown. Tighten with a Phillips

Insert screw with washer in front of screwdriver.

tank area. Tighten screw with a

Phillips screwdriver.

Replace clean solution tank by posi-

tioning bottom first. Press latch and

snap top portion into place.

To install brushes, place handle in

upright position. Tilt cleaner back so

that it rests on the floor.

Align post (C) on brush block with

hole (D) on bottom of cleaner. Turn

brushes slightly until post fits easily

into hole.

Press brush assembly firmly to snap

into place.

To install nozzle, make sure latches

are out.

Align middle section (E) of nozzle with

opening (F) on cleaner.

Remove cardboard packing insert

from squeegee area on underside of

nozzle.

While holding nozzle in place, slide

latches inward to lock in place.