EN User instructions ® HFI 4015 DISHWASHER
CONTENTS pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag.
SAFETY INSTRUCTIONS WARNING ! Knives and other utensils with sharp points must be loaded in the basket with their points down or placed in a horizontal position. There are certain basic safety rules which are valid for any domestic appliance. Installation Daily use ■ Make sure that the plug fitted to the machine is compatible with the power supply socket.
Water connection ■ The hose can be hooked over the side of the sink, but it must not be immersed in water, in order to prevent water from being syphoned back to the machine when this is in operation (fig. 4Y). Connecting the outlet hose IMPORTANT The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused. 1 ■ The outlet hose should disharge into a standpipe, making sure that there are no kinks (fig. 4).
WATER SOFTENER UNIT * The softener unit is set in the factory at level 4 (d4) as this satisfies the requirements of the majority of users. Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks. The higher the level of these minerals present in the water, the harder the water is.
ADJUSTMENT OF THE UPPER BASKET A standard daily load is represented in figs. 1 and 2. LOADING DISHES 1 Upper basket (fig. 1) A = soup plates B = dinner plates C = dessert plates Using the upper basket If 27 cm to 31 cm plates are normally used, load them onto the lower basket after the upper basket has been placed in its upper position and proceed as detailed below: 1. Pull out the upper basket; 2. Then grasp the basket from both sides and lift it upwards (fig. 1).
■ The lower basket is fitted with a special adjustable central rack (fig. 3 and 4). This permits stable and optimum loading, even when the size and/or shape of the dishes is non-standard. INFORMATION FOR THE TEST LABORATORIES 5 General programme comparison (Ref. EN 50242 Standards) (see programmes selection) 4. Amount of detergent: - 9,5 g for pre-wash; - 28 g for wash. 1. Upper basket position: low 2. Normal load 3.
■ the effectiveness of detergents containing the built in water softener/salt depends on the hardness of your water supply. Check that the hardness of your water supply is within the effective range given on the detergent packaging. TYPES OF DETERGENT LOADING THE DETERGENT Detergent tablets The detergent IMPORTANT It is essential to use a detergent that is specifically designed for dishwashers either in powder, liquid or tablet form.
LOADING THE RINSE AID CLEANING THE FILTERS The rinse aid The filter system (fig.A “4”) consists of: The rinse aid, which is automatically released during the last rinsing cycle, helps the dishes to dry quickly and prevents spots and stains forming. a flat gauze that continuously filters the wash water; Filling the rinse aid container dark a micro filter, located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse.
PRATICAL HINTS How to make savings ■ If you want the dishwasher to give a complete wash, place the dishes in the dishwasher at the end of each meal and if necessary turn on the COLD RINSE cycle to soften the food remains and remove bigger particles of food from the new load of dishes. When the dishwasher is full start the complete wash cycle programme.
DESCRIPTION OF THE CONTROL PANEL PROGRAMME SELECTION AND SPECIAL FUNCTIONS “AUTOMATIC” programmes (Use in conjunction with programme guide) The dishwasher is equipped with a dirt sensor, able to analyse water murkiness during all "AUTOMATIC" programme phases (see programme list); thanks to this sensor the washing cycle parameters are automatically adapted to the real quantity of dirt on dishes. Thus excellent washing results are guaranteed while optimising water and energy consumption.
“3 in 1” button Changing a running programme This option optimises the use of “3 in 1”/ “4 in 1”/“5 in 1” combined detergents. By pressing this button, the selected washing programme is modified to get the best performance from combined detergents; furthermore, the salt and rinse aid shortage lights are de-activated. Proceed as follows to change or cancel a running programme: ■ Open the door. ■ Hold the "START" button down for at least 5 seconds (the running programme will be cancelled).
The dishwasher is able to signal a series of faults in the display. THE WATERBLOCK SYSTEM AUTOMATIC FAULT SIGNALS FAULTS E2 appears on the display and the alarm sounds. CAUSE No water (inlet hose closed). SOLUTION Turn off the dishwasher, open the inlet hose and reset the cycle. The waterblock system has been designed to improve the safety of your appliance, particularly when the machine is left unattended.
PROGRAMME GUIDE UNIVERSAL (“RECOMMENDED” PROGRAMME) Once a day - for normal soiled pans and any other items that have been left all day for washing. INTENSIVE Once a day - for heavily soiled pans and any other items that have been left all day for washing. DELICATE Suitable for delicate crockery and glassware. Also for less soiled items excluding pans. A Suitable for heavily soiled items that are to be washed straight after a meal (Max 8 place load).
IDENTIFYING MINOR FAULTS FAULT Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks: CAUSE See causes for no.
Hoover guarantees all parts of this product for 5 years from the date of purchase. During that time Hoover will replace or repair all defective parts free of charge, except for parts subject to fair wear and tear such as belts. The call out fee and labour costs are chargeable after the first 12 months.
HOOVER SERVICE FOR YOUR LOCAL ENGINEER PLEASE CALL OUR NATIONAL NUMBER 08705-400600 EIRE 01 8301666 06.11 - 41023227 - www.graficaestampa.
