INSTRUCTION BOOK VTC 680C Condenser Tumble Dryer English 2
Introduction Delivery Information Unpacking the Product Safety Reminders Use Installation The Laundry Environmental Issues Gias Service Installation Electrical Requirements Adjusting the Feet Ventilation Preparing the Load Clothes Preparation Do Not Tumble Dry Energy Saving Sorting the Load Drying Guide Controls and Indicators Selecting the Programme Door and Filter Opening the Door Filter Filter Care Indicator Water Container To Remove the Container Condenser To Remove the Condenser Operation Delay Start F
INTRODUCTION Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. Keep all documentation in a safe place for future reference or for any future owners.
SAFETY REMINDERS Installation ● Check that the product has no visible signs of damage before use. If damaged do not use and please call GIAS Service. ● Do not use adapters, multiple connectors and/or extensions. ● Never install the dryer against curtains and be sure to prevent items from falling or collecting behind the dryer. ● The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the tumble dryer.
INSTALLATION Electrical Requirements Tumble dryers are supplied to operate at a voltage of 220V-240V, 50 Hz single phase. Check that the supply circuit is rated to at least 10A VENTILATION Adequate ventilation must be provided in the room where the tumble dryer is located to prevent gases from appliances burning other fuels, including open fires, being drawn into the room during operation of the tumble dryer. Electricity can be extremely dangerous. This appliance must be earthed.
PREPARING THE LOAD Before using the tumble dryer for the first time: ● Please read this instruction book thoroughly. ● Remove all items packed inside drum. ● Wipe the inside of the drum and door with a damp cloth to remove any dust which may have settled in transit. Clothes Preparation Make sure that the laundry you are going to dry is suitable for drying in a tumble dryer, as shown by the care symbols on each item. Check that all fastenings are closed and that pockets are empty.
CONTROLS AND INDICATORS Programme Selector Delay Start Button Delicates Button Control Panel and Indicator Lights Programme Selector – Select the required programme Delay Start button – Allows the user to delay the start of the drying cycle (see details of Operation on page 10) Start/Pause button – Press to commence the selected drying programme Delicates button – Press to reduce the heat level for delicate items, the indicator above the button will light up.
SELECTING THE PROGRAMME PROGRAMME DESCRIPTION Bone Dry Extra Dry Cupboard Dry Select the degree of dryness that you require. This ranges from Bone Dry cycle for bath towels and bathrobes, Extra Dry cycle through for items that will be put away without ironing, to the programme that leaves the laundry suitable for ironing. Iron Dry Wool Finish A gentle programme specially created to get woollens softer after air-drying.
DOOR and FILTER Opening the Door Pull on handle to open the door. To restart the dryer, close the door and press Start/Pause button . WARNING! When the tumble dryer is in use the drum and door may be VERY HOT. Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. Filter IMPORTANT: To maintain the efficiency of the dryer check that the fluff filter is clean before each drying cycle. 1.Pull the upwards. filter 2.
CONDENSER Important: Always switch off and remove the plug from the electricity supply before cleaning the condenser. To maintain the efficiency of the dryer regularly check that the condenser is clean. To Remove the Condenser 1.Remove kickplate OPERATION 1. Open the door and load the drum with laundry. Ensure that garments do not hinder closure of the door. 2. Gently close the door pushing it slowly until you hear the door 'click' shut. the 3.
OPERATION Delay Start Function The Delay Start Function allows the user to delay the start of the drying cycle by 3, 6 or 9 hours. When the function is first selected the display will show a delay of 3 hours, subsequent presses of the button will increase the delay to 6 or 9 hours. To commence the programme press Start/Pause and the appliance will complete the drying cycle at the end of this time. The 3, 6 or 9 hour indicator light will flash to indicate that the start delay is in progress.
TROUBLESHOOTING What Might be the Cause of... Defects you can remedy yourself Before calling GIAS Service for technical advice please run through the following checklist. A charge will be made if the machine is found to be working or has been installed incorrectly or used incorrectly. If the problem persists after completing the recommended checks, please call GIAS Service, they may be able to assist you over the telephone.
YOUR GUARANTEE For a period of one year from the date of purchase the appliance is covered by a guarantee which allows you to call GIAS Service free of charge. Remember to send off the guarantee certificate for validation within 10 days of the date of purchase. You should retain the receipt issued by the retailer when you purchased the machine to show to the call out engineer, should you need to consult one.
40007269
