USER MANUAL
GB IMPORTANT SAFETY REMINDERS aerosols or their vapours. This appliance should only be used for domestic cleaning, as described in this user guide. Please ensure that this guide is fully understood before operating the appliance. Do not run over the power cord when using your appliance or remove the plug by pulling on the power cord. Do not leave the appliance plugged in. Always switch off and remove the plug from the socket after use, or before cleaning the appliance or any maintenance task.
GB GETTING TO KNOW YOUR CLEANER HANDLE END CAP Effortless cleaning with your new Hoover LOOP HANDLE* AUTO BUTTON METAL TUBE PRE-MOTOR FILTER BIN RELEASE BUTTON MAIN POWER BRUSH BAR ON/OFF SWITCH ON/OFF BUTTON BIN HANDLE MINI TURBO NOZZLE* EXTENSION HOSE* DUST BIN 2IN1 DUSTING & CREVICE TOOL EXTENSION TUBE* LONG CREVICE TOOL* SUCTION CONTROL EXTENSION HOSE SOCKET EXHAUST FILTER GRILLE LED LIGHTS NOZZLE WIPER BLADES WHEELS EXHAUST FILTER * Certain models only -2-
GB 2. AUTO button Press the Auto button to turn ON or OFF the FLOOR SENSOR function. PREPARING YOUR CLEANER Insert the main handle in the cleaner body and then adjust handle up/down to the desired height. 2 1 SUPPLY CORD Do not run over the supply cord. Clip the supply cord in the cord clip at the back of the handle to avoid accidentally running the cleaner over the cord and causing any damage.
3 LED LIGHTS Plug the lower hose end in the hose socket. 4 Choose your accessory and connect it to the hose. 5 Connect the hose to the handle tube. Connect the accessory to the handle tube. This vacuum cleaner has nozzle LED lights. They are perfect to light up dark areas to leave nothing behind and to have an excellent cleaning experience. WIPER BLADE ASSEMBLY Connect Accessory to Handle Tube 1 The front wiper blade supplied in the instruction manual package is not necessary for normal cleaning.
GB EMPTYING THE BIN ! IMPORTANT: Before emptying the bin, make sure vacuum cleaner has been switched off. CLEANING THE PRE MOTOR FILTERS 1 3 Rotate the upper part of the dust bin to open. Gently tap both filters to release any excess dust. 2 Take out the pre motor filter and the separation unit from the dust bin. clean excess debris from the separation unit and refit. 4 Wash both filter and sponge under warm water until the water runs clean.
GB CHANGING THE BELT OR BRUSHES CLEARING A BLOCKAGE If your cleaner is not picking up efficiently, the belt or brushes (or both) may need replacing, but first please make sure you have: IMPORTANT: Switch the cleaner off and • Emptied the bin remove the plug from the electricity supply • Cleaned the filters before attempting any maintenance. • Checked for blockages 1 2 3 Turn the cleaner over and remove 2 rear rollers and 2 retaining screws. Remove the brush guard.
GB IMPORTANT INFORMATION User checklist If your cleaner is not working properly run through the following checklist. 1. Is there a working electricity supply to the cleaner? Check with another electrical product. 2. Is the bin full or choked with fine dust? To empty the bin, see the User Manual on P5. 3. Is the hose blocked? To clear a blockage, see the User Manual on P6. 4. Is there a blockage in the cleaner base? To clear a blockage, see the User Manual on P6. 5.
PRINTED IN P.R.C.