Operation Manual

- 4 -
PREPARING TO USE YOUR CLEANER
CARPET CARE CONTROL
SELECTOR
CLEANER LOCK RELEASE
The carpet care control selector raises or lowers the
height of the nozzle. The nozzle height will not change
until the handle is released. Try various settings until you
get the best results for each of your carpets.
Ensure that the cleaner
is in an upright (parked)
position.
Slide selector to the
position best suited to
depth of carpet pile.
Note: Using this cleaner for loop carpets or carpets with
pile greater than 30mm is not recommended. Please
consult the oorcare/carpet manufacturer’s recommended
cleaning instruction before vacuuming.
Unlock the cleaner by pressing
down on pedal with foot. For
oor cleaning under low
furniture and some
maintenance tasks
simply press the
pedal again and
lower handle
to the oor.
IMPORTANT: When cleaning hard
oors such as vinyl or linoleum, move
the “Carpet Care Control Selector” to
the Hard oor position. Failure to do so
may cause damage to the oor surface.
!
- 4 -
POWER SWITCH SETTING
Switching on and off
Push bottom of the On/Off switch to switch on.
Push top of the On/Off switch to switch off.
1
Insert handle into body of cleaner.
Slide into position.
Ensure handle is ush with body of
cleaner.
Tighten large screw (pre-tted to
handle upper hole). Insert small
screw into handle lower hole and
tighten.
Connect hose to back of
product.
Latch hose retainer
to hose support.
Afx carrying handle to
the back of product
Screw top two provided
screws to afx carrying han-
dle in place
48000164 - 3 Purepower UK IM.indd 4 18/11/2010 11:08:15