User's Manual

3
4. Wash it in hand warm water, [19] and allow it to dry thoroughly before replacing it
in the cleaner.
Cleaning the Exhaust Filter:
1. To remove the exhaust lter, unclip the exhaust lter cover [20] and remove the
exhaust lter pack.[21]
2. Wash the lter in hand warm water [19] and allow it to dry thoroughly before
replacing in the cleaner.
REMEMBER: Do not use hot water or detergents. In the unlikely event of the lters
becoming damaged, t a genuine Hoover replacement. Do not try and use the product
without a dust bag or lter tted.
Cleaning the Permanent Cloth Dust Bag* :
To maintain optimum performance we recommend that you wash the permanent cloth
dust bag under hand warm water after every 5 full bags. Remove excess water and leave
to dry fully before replacing.
Removing a Blockage From The System:
If the Bag Check Indicator is red:
1. Check if the bag is full. If so refer to ‘Replacing The Dust Bag’.
2. If it is not full, then;
A. Do the lters need cleaning? If so refer to ‘Cleaning the Filter’.
B. Check if there is any other blockage in the system - Use a rod or a pole to remove
any blockage from Telescopic Tube or exible hose.
WARNING* : The bag check indicator will remain illuminated if the cleaner is used when
the bag is full, if there is a blockage or if the lters are dirty. If used for a period over
ten minutes with the bag check indicator illuminated, an electronic cut out will switch
the cleaner off to prevent any risk of overheating. If this should happen, switch the
cleaner off, unplug and correct the fault (see ‘Removing a blockage’). The cut out will
automatically reset upon switching the cleaner back on.
ACCESSORIES AND NOZZLES
To obtain the best performance and energy efciency
#1
it is recommended that the
correct nozzles are used for the main cleaning operations. These nozzles are indicated
in the diagrams by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard oor.
A nozzle type HF is suitable for use only on hard oor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as re-
quired by European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
If the label shows a red prohibition circle on the right covering the hard oor symbol, then
this indicates that the vacuum cleaner is not suitable for use on hard oors.
#1
NOTE: Dust pick up ability carpet, dust pick up ability hard oor, and energy efciency
in accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
The Crevice tool, Furniture nozzle and Dusting brush are stored on board under the
accessories door [22]
All accessories can be tted to the end of the handle or the end of the Telescopic* Tube.
Crevice Tool – For corners and hard to reach areas. [23]
Furniture Nozzle – For soft furniture and fabrics. [24]
Dusting Brush – For bookshelves, frames, keyboards, etc. [25]
Pet Hair Remover Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for pet
hair removal. [1V]
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for
deep cleaning on textile surfaces and other hard to clean areas. Particularly suitable for
allergen removal. [1W]
Grand Turbo Nozzle* - Use the Grand Turbo Nozzle for deep cleaning on carpets. [1X]
Hard Floor Caresse Nozzle* - For parquet oors and other delicate oors. [1Y]
IMPORTANT: Do not use the Grand Turbo Nozzle on rugs with long fringes, animal hides and
carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is rotating.
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
• Is the dust bag over-filled? Please refer to ‘Cleaner Maintenance’.
• Is the filter blocked? Please refer to ‘Cleaner Maintenance’.
•
Is the hose or nozzle blocked? Please refer to ‘Removing a blockage from the system’.
• Has the cleaner overheated? If so, it will take approximately 45 minutes for the cut
out to automatically reset.
•
*Certain Models Only ** Certain models only, nozzles may vary according to model