USER MANUAL
IMPORTANT SAFETY REMINDERS aerosols or their vapours. GB This appliance should only be used for domestic cleaning, as described in this user guide. Please ensure that this guide is fully understood before operating the appliance. Do not run over the power cord when using your appliance or remove the plug by pulling on the power cord. Do not leave the appliance plugged in. Always switch off and remove the plug from the socket after use, or before cleaning the appliance or any maintenance task.
GB GETTING TO KNOW YOUR CLEANER Effortless cleaning with your new Hoover HANDLE CORD CLIP HANDLE HOSE STORAGE HOOK BIN RELEASE button CORD STORAGE HOOK BIN WASHABLE HEPA FILTER & MESH FRAME 2 IN 1 TOOL HOSE EXTENSION TUBE AND LONG CREVICE Tool This vacuum cleaner is supplied with an Energy Label as required by European Regulation (EU) 665/2013.
PREPARING YOUR CLEANER Carpet care control selector Insert the main handle in the cleaner body and then fix it with the screw provided. To tighten the screw you can use a standard coin. Ensure that the cleaner is in the upright (parked) position and move the selector to the required setting for the carpet type or floor covering. To obtain the best performance and energy #1 efficiency it is recommended that the adjustment setting position 1 is used for the main cleaning operations.
CLEANING TOOLS CLEANING THE STAIRS Handle All accessories can fit onto the end of the hose. Combine accessories depending on use. Pet Hair & Allergen Remover* The pet hair & allergen remover is ideal for removing pet hairs. DO NOT touch the rotating brush. 1 Remove the short stretch hose from the Hose socket. Plug in the longer stretch hose in the hose socket. 2 Pull out extension tube and long crevice tool. 3 Both short and long stretch hoses are supplied with the cleaner.
EMPTYING THE Bin 1 GB CLEANING THE PRE MOTOR FILTERS To remove the bin from the cleaner press the bin release button. 1 Rotate the upper part of the dust bin to open. 2 Remove the filter assembly from the bin top by rotating the filter. It is advisable to wash the filters after every 5 bin empties. 4 Wash both filter and protective mesh under warm water until the water runs clean. Remove excess water by shaking and leave to dry for 24 hours.
CHANGING THE BELT OR BRUSHES CLEARING A BLOCKAGE If your cleaner is not picking up efficiently, the belt or brushes (or both) may need replacing, but first please make sure you have: • Emptied the bin • Cleaned the filters • Checked for blockages 1 Turn the cleaner over and remove 6 retaining screws attaching the brush guard to the base. IMPORTANT: Switch the cleaner off and remove the plug from the electricity supply before attempting any maintenance.
GB Important information User checklist Hoover Service Should you require service at any time, please contact your local Hoover Service Office. If your cleaner is not working properly run through the following checklist. 1. Is there a working electricity supply to the cleaner? Check with another electrical product. 2. Is the bin full or choked with fine dust? To empty the bin, see instructions on P6. 3. Is the hose blocked? To clear a blockage, see instructions on P7. 4.
PRINTED IN P.R.C.
