product manual

10
Filter Made With HEPA Media: How to Clean
4.7 Remove dirt cup.
4.8 Unlock filter Door (A).
4.9 Remove the filter and hold over a trash
receptacle and tap out dirt and debris.
Return filter and replace dirt cup on vacuum.
Filter Made With HEPA Media: What to Buy
When used and maintained properly, your Filter should not need replacement
within the warranty period. If desired, additional filter is available. Ask for
Hoover
®
Part No. 303902001.
CAUTION
! !
To reduce the risk of injury from moving parts,
unplug vacuum before servicing. Do not use
vacuum without dirt cup or filters in place.
IMPORTANT
DO NOT RINSE OR WASH THE FILTER CARTRIDGE.
4.8
A
4.9
4.5
To maintain optimal performance, filters should be
cleaned every two months under normal use.
FILTERS: When to Clean
4.6
CAUTION
! !
To reduce the risk of injury from moving parts,
unplug vacuum before servicing. Do not use
vacuum without dirt cup or filters in place.
IMPORTANT
Allow filter to dry completely before replacing.
Dry filter on edge so air circulates on both sides
of filter. This may take up to 24 hours.
When used and maintained properly, your Rinsable
Filter should not need replacement within the
warranty period. If desired, additional filter is
available. Ask for Hoover
®
Part No. 303903001.
Rinsable Filter: What to Buy
Rinsable Filter: How to Clean
Remove dirt cup as described in Fig. 4.2.
4.5 Twist the dirt cup lid to open.
4.6 Pull tab to remove rinsable filter.
Rinse with water for two minutes or until water runs
clear. Then squeeze out excess water. Allow 24
hours for filter to dry completely.
Replace filter, tab side out.
Close lid securely by twisting dirt cup lid until it clicks
as shown in Fig. 4.5.
Replace dirt cup as described in Fig 4.4.
4.7