product manual

12
Cyclonic Filter Assembly: How to Clean
4.9
4.10
4.11
What to Buy: Carbon Filter
Carbon Filter may need to be replaced more
often to maintain optimal odor absorbing
effectiveness Additional filter is available at
Hoover com or call 1 800 944 9200 Ask for
Hoover
®
Part 902404001
Carbon Filter : How to Clean
(Available on select models only).
Your Carbon Filter is located on the underside of
the Filter made with HEPA media
IMPORTANT
DO NOT R NSE OR WASH the Carbon Filter
BRUSHROLL: How to Clean
4 13 Turn vacuum over so bottom side is facing up
and remove the (6) screws (A)
4 14 Pivot out bottom plate away from hidden latch
(B) and remove any debris and/or hair from the
brushroll
4 15 Reposition bottom plate aligning latch (B) and
fastening all (6) screws (A) Press firmly at latch (B)
area to ensure that it is properly latched
4.13
A
CAUTION
! !
To reduce the risk of injury from moving parts
Unplug before servicing
Replace dirt cup as described in Fig 4 5
B
C
A
4.12
4.15
A
B
4.14
B
To reduce the risk of personal injury Unplug
before cleaning or servicing Do not use
vacuum without dirt cup or filters in place
WARNING
! !
Remove dirt cup as described in Fig 4 3
4 9 Twist filter assembly (A) counter clockwise
Remove assembly from dirt cup
4 10 Dirt and debris can be cleaned from the filter
assembly with the Dusting/ Upholstery Tool
4 11 f further cleaning of the internal filter assembly
is required turn dust skirt (B) counterclockwise to
remove
4 12 Grab dirt cup shroud (C) pull straight off and
clean with dusting/upholstery tool
After cleaning replace dirt cup shroud (C) onto
inside edge of filter assembly and align Place skirt
(B) onto shroud align (4) slots with (4) tabs and turn
clockwise to lock
Place the filter assembly (4 9 A) on the dirt cup
aligning (3) tabs on filter with (3) slots on dirt cup (B)
and twist it clockwise to secure into position
Actual model may vary from images shown.