Instruction Manual

ManualsBrandsHope Tech ManualsLightingPress-Fit PF46 Bottom Bracket

Press Fit 46mm Bottom Bracket For 24mm crank spindles

1. Install the drive side cup (with bearing tted).

We strongly advise that this bottom bracket is installed and maintained by a competent cycle mechanic, using Hope Bottom Bracket Tool (HTTPFA).

This bottom bracket is intended for installation in bottom bracket shells with an internal diameter of 46mm and widths of 68mm, 73mm or 83mm.

Check internal edges of bottom bracket shell and remove any burrs or paint build-up prior to tting.

Drive side cup

(Item No. 5)

Ensure outer seal rings are

not installed at this stage

Hold this end stationary

using a 27mm spanner

Drive side cup is installed

Unscrew the nut and remove the tool

Drive side cup is now fully ush with the BB shellTighten the nut using a 19mm spanner

until the drive side cup is pulled fully

ush with the bottom bracket shell

Apply grease to the internal

surface of the B.B. shell

Tools required:

19mm spanner Hope Bottom Bracket Tool

(HTTPFA)

27mm spanner GreaseRubber Mallet

HOPE TECHNOLOGY

Hope Mill,

Barnoldswick,

Lancashire,

ENGLAND

BB18 6NG

www.hopetech.com

BBPF466824SSN / BBPF466824CRN

BBPF466824SSN

BBPF466824CRN

BBPF467324SSN

BBPF467324CRN

BBPF468324SSN

BBPF468324CRN

BBPF467324SSN / BBPF467324CRN

BBPF468324SSN / BBPF468324CRN

ITEM NO. HOPE PART NO. DESCRIPTION

1 BBSP104 Outer Seal Ring

BBSP108:S 24mm BB Stai nless Steel Be aring

BBSP108:C 24mm BB Ceramic Be ari ng

3 BBSP111 24mm Bolt-in Centre Tube

BB008-3 PF46 68 24 Non- Dri ve Side Cup

BB004-1 PF46 73 24 Non- Dri ve Side Cup

BB005-1 PF46 83 24 Non- Dri ve Side Cup

BB008-2 PF46 68 24 Drive Si de Cup

BB004-2 PF46 73 24 Drive Si de Cup

BB005-2 PF46 83 24 Drive Si de Cup

68mm

46mm

73mm 83mm

NDS DS NDS DS NDS DS

Summary of content (2 pages)

PAGE 1
Press Fit 46mm Bottom Bracket For 24mm crank spindles Tools required: HOPE TECHNOLOGY Hope Mill, Barnoldswick, Lancashire, ENGLAND BB18 6NG BBPF466824SSN / BBPF466824CRN BBPF467324SSN / BBPF467324CRN BBPF468324SSN / BBPF468324CRN 27mm spanner 19mm spanner Hope Bottom Bracket Tool (HTTPFA) Rubber Mallet Grease www.hopetech.com We strongly advise that this bottom bracket is installed and maintained by a competent cycle mechanic, using Hope Bottom Bracket Tool (HTTPFA).
PAGE 2
. Install the non-drive side cup (without bearing fitted). Non-drive side cup is now fully flush with the BB shell Tighten the nut using a 19mm spanner until the non-drive side cup is pulled fully flush with the bottom bracket shell Non-drive side cup is installed Hold this end stationary using a 27mm spanner Non-drive side cup (Item No. 4) Apply grease to the internal surface of the B.B. shell Unscrew the nut and remove the tool 3. Install the centre tube. 4. GXP conversion only.