User guide

ManualsBrandsHope Tech ManualsLightingPress-Fit PF46 Bottom Bracket

Press Fit 46mm Bottom Bracket For 30mm crank spindles

1. Install the drive side cup (with bearing tted).

We strongly advise that this bottom bracket is installed and maintained by a competent cycle mechanic, using Hope Press Fit BB Tool (HTTPFA) with the 30mm Adapter Kit (HTT185).

This bottom bracket is intended for installation in bottom bracket shells with an internal diameter of 46mm and widths of 73mm or 83mm.

Check internal edges of bottom bracket shell and remove any burrs or paint build-up prior to tting.

Ensure that the bearings (S71806) are tted the correct way with the green seal facing outside.

Drive side cup is installed

Unscrew the nut and remove the tool

Drive side cup is now fully ush with the BB shell

Tools required:

19mm spanner Hope Press Fit BB Tool

(HTTPFA)

Hope Press Fit BB Tool

30mm Adapter Kit (HTT185)

27mm spanner GreaseRubber Mallet

HOPE TECHNOLOGY

Hope Mill,

Barnoldswick,

Lancashire,

ENGLAND

BB18 6NG

www.hopetech.com

BBPF467330SSN

BBPF468330SSN

NDS DS

BBPF467330SSN

46mm

73mm

NDS DS

BBPF468330SSN

83mm

ITEM NO. HOPE PART NO. DESCRIPTION

1 BB003-4 30mm Alloy Seal Ring

2 S71806 30mm BB Stainless Steel Bearing

3 BB006-3 30mm Bolt-in Centre Tube

BB006-1 PF46 73 30 Non-Drive Si de Cup

BB007-1 PF46 83 30 Non-Drive Si de Cup

BB006-2 PF46 73 30 Drive Side Cup

BB007-2 PF46 83 30 Drive Side Cup

Hold this end stationary

using a 27mm spanner

Tighten the nut using a 19mm spanner

until the drive side cup is pulled fully

ush with the bottom bracket shell

Drive side cup

(Item No. 5)

Ensure outer seal rings are

not installed at this stage

Apply grease to the internal

surface of the B.B. shell

30mm bearing adapter

(from kit HTT185)

Summary of content (2 pages)

PAGE 1
Press Fit 46mm Bottom Bracket For 30mm crank spindles Tools required: HOPE TECHNOLOGY Hope Mill, Barnoldswick, Lancashire, ENGLAND BB18 6NG BBPF467330SSN BBPF468330SSN 27mm spanner 19mm spanner Hope Press Fit BB Tool (HTTPFA) Hope Press Fit BB Tool 30mm Adapter Kit (HTT185) Rubber Mallet Grease www.hopetech.com We strongly advise that this bottom bracket is installed and maintained by a competent cycle mechanic, using Hope Press Fit BB Tool (HTTPFA) with the 30mm Adapter Kit (HTT185).
PAGE 2
. Install the non-drive side cup (without bearing fitted). Tighten the nut using a 19mm spanner until the non-drive side cup is pulled fully flush with the bottom bracket shell Non-drive side cup is now fully flush with the BB shell Non-drive side cup is installed Hold this end stationary using a 27mm spanner 30mm bearing adapter (from kit HTT185) Non-drive side cup (Item No. 4) Apply grease to the internal surface of the B.B. shell Unscrew the nut and remove the tool 3. Install the centre tube. 4.