Specifications

E-mail:[e-mail] Rev1.0
RFM90C
www.hoperf.cn
Picture 3: RFM90C Module Configuration
HOPEMICROELECTRONICS
CO.,LTDAdd:2/F,Building3,pingshan Private
Enterprise science and Technology Park,xili
Town,Nanshan District,
Tel: [phone]
Fax: [phone]
Email: [e-mail]
Website: http://www.hoperf.com
http://www.hoperf.cn
This document may contain preliminary information and is subject to change by
Hope Microelectronics without notice. Hope Microelectronics assumes no
responsibility or liability for any use of the information contained herein. Nothing
in this document shall operate as an express or implied license or indemnity under
the intellectual property rights of Hope Microelectronics or third parties. The
products described in this document are not intended for use in implantation or
other direct life support applications where malfunction may result in the direct
physical harm or injury to persons. NO WARRANTIES OF ANY KIND,
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIESOF
MECHANTABILITY ORFITNESSFOR A ARTICULARPURPOSE,AREOFFER
EDIN THISDOCUMENT.
©2006,HOPEMICROELECTRONICSCO.,LTD.Allrightsreserved.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generate, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on
a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.