User's Manual

04
05
WA   
 B 
A

H   H

 
How to use an charge the Power  ngine Bloc  
0
▶ How to use the Power Engine Block(RF)
▶ How to charge the Power Engine Block(RF)
When the USB cable is plugged in, a yellow-green light appears on the front. When it is done charging, the yellow-green light turns off. If you
operate the Power Engine Block(RF) while charging, the light may look orange. The proper charging time is approximately 3 hours. Charging in
DQ\ZD\RWKHU¢WKDQWKHUHFRPPHQGHGPHWKRGPD\FDXVHDPDOIXQFWLRQ¢3OHDVHXVHD3&RUODSWRSWRFKDUJHWKHSURGXFW¢
When you connect the blocks below,
Magformers models will show various
movements.
When the light appears on the front, press
the button once to operate the Power
Engine Block(RF). Press again to operate in
the reverse direction and press once again
to stop.
When you turn on the switch,
a red light appears and the Power Engine
Block(RF) becomes ready to use.
※ If the model goes backwards when you control it, turn the Engine Watch button to the opposite direction, or press the power button of the Power Engine
Block(RF) once more to make it move forward.
RF)
E
i
Wt
h
bt
t
t
th
it
d
i
ti
Power Engine Block(RF)
PC / Laptop
USB Cable