Rev. 1.
821E_Rev.1.1.indd 4-5 NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended. Unpack the product where you will be using it. Place the product on a level flat surface. It is recommended that you place a protective covering on your floor. During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt.
GUIDE RAILS MAIN FRAME BOLT(A) M8x1.25Px15L Qty:2 HARDWARE BAG FOR STEP 2 CONTENTS : BOLT(A) AS S EMB LY STE P 2 waher (A) 16.0x 25x1.5T Qty:2 NOTE: You may have to rotate the guide rails back and forth to get them to slide into the frame. C) Attach GUIDE RAILS using 2 BOLTS (A). B) Slide left and right GUIDE RAILS into MAIN FRAME. A) Open HARDWARE BAG FOR STEP 2. screw(C) M8x1.25Px12L Qty:2 A) Open HARDWARE BAG FOR STEP 1.
LOWER HANDLEBAR PRE ATTACHED SCREWS PRE - ATTACHED BOLT & WASHER SCREWS(A) Qty: 4 4x15L SCREW (A) HARDWARE BAG FOR STEP 5 CONTENTS : HANDLEBAR COVER CONSOLE MAST ASSEMBLY STEP 5 Teflon Washer (A) 10.4x 24.75x1.5t Qty: 4 HARDWARE BAG FOR STEP 4 CONTENTS : REAR WHEEL COVER Nylon Nut (B) M10x1.5P Qty: 2 Teflon Washer (A) PEDALARM COVER Pre-attached screw(C) Teflon Washer (A) PRE-ATTACHED SCREW (C) PEDAL ARM NYLON NUT(B) PIVOT-TUBE (F) Repeat on the other side.
(B) (H) (I) (D) PEDAL BASE (G) (E) (F) LINKAGE TUBE LINKAGE ARM (C) HANDLEBAR LNKAGE PIECE (G) (C) linkage axle (F) Qty:1 screw (A) Qty:3 washer (B) Qty:1 PRE-ATTACHED HARDWARE PARTS: screw (G) Qty:2 washers (C) Qty:2 washers (H) Qty:4 nut (D) Qty:1 screws (I) Qty:4 screw (E) Qty:1 Andes509: A) Remove PRE-Attached washer (B) & screws (A) from end of the linkage arm . B) Attach the linkage arm to the pedal arm tube using 3 screws (A) and 1 washer (B).
