Installation Instructions

5554
USING YOUR MEDIA PLAYER
1) Connect the included AUDIO ADAPTOR CABLE to the AUDIO IN JACK on the console and the headphone jack on your
media player.
2) Use your media player buttons to adjust song settings.
3) Remove the AUDIO ADAPTOR CABLE when not in use.
SYNCING BIKE WITH PASSPORT
(COMFORT 3 IS NOT INCLUDED)
1) Using the arrow key on the passport remote control to scroll to the setup icon
and press the Select.
2) Follow the on-screen prompt to press and hold the RESISTANCE UP and
CHANGE DISPLAY buttons on the equipment’s console for 3-5 seconds.
3) Once your sync is successful, your bike message bar will change from RF Sync
to Passport Ready.
4) The message displayed on-screen will notify you if the sync was successful or
failed.
ENERGY SAVER MODE
This machine is equipped with Energy Saver mode. When Energy Saver mode is activated, the display will automatically enter
standby mode (Energy Saver mode) after 15 minutes of inactivity. This feature saves energy by disabling most power to the machine
until a key is pressed on the console. You may switch this function on and off using engineering menu.
Eingaben
Press and hold
CHANGE DISPLAY+RESISTANCE UP
to start syncing with Passport
ENGINEERING MODE:
To enter the engineering menu, press and hold the and for 3-5 seconds.
SWITCHING BETWEEN BRITISH AND METRIC MODE
Use the and arrow keys to navigate to Eng2 and press Enter. Use the Enter key to navigate to P1. Use the and arrow
keys to switch between STANDARD (BRITISH) and METRIC.
SWITCHING DISPLAY LANGUAGE
Use the and arrow keys to navigate to Eng2 and press Enter. Use the Enter key to navigate to P2 Press ENTER to select
language mode, use arrow keys to select the language you desire.
Press and hold STOP for 3-5 seconds to exit ENG2. Press and hold STOP again for 3-5 seconds to exit the engineering
menu.
SWITCHING ON/OFF THE ENGERGY SAVER FUNCTION
Use the and arrow keys to navigate to Eng2 and press Enter. Use the Enter key to navigate to P5.
Press ENTER to select Energy Saver mode, use the
and arrow keys to select ENRGY SAVE ON or OFF. Press and hold
STOP for 3-5 seconds to exit ENG2. Press and hold STOP again for 3-5 seconds to exit the engineering menu.