Installation Instructions

2120

A Open HARDWARE FOR STEP 3.

B Slide WATER BOTTLE HOLDER up CONSOLE

MAST and align screw holes in WATER BOTTLE

HOLDER with holes in CONSOLE MAST.

C Attach the WATER BOTTLE HOLDER using 2

SCREWS (D).

HARDWARE FOR STEP 3 :

WATER BOTTLE HOLDER

CONSOLE MAST

SCREW (D)

M4x12 mm

Qty: 2

Note: Be careful not to pinch any cable while

assembling.

UPRIGHT BIKE ASSEMBLY STEP 2

Note: There is no hardware needed at this step.

A Attach the S EAT to the SEAT POST TUBE and

tighten the SEAT NUTS by using 13mm wrench.

(You may need additional 13mm wrench to make the

seat assembly more easier.)

B Loosen the SEAT HEIGHT ADJUSTMENT KNOB by

turning it two half turns counter-clockwise.

C Then pull the SEAT HEIGHT ADJUSTMENT KNOB

outward while sliding the SEAT POST TUBE into the

MAIN FRAME.

S EAT

SEAT POST TUBE

SEAT HEIGHT

ADJUSTMENT KNOB

MAIN FRAME

Comfort

Upright

Bike

COMFORT 3 SHOWN COMFORT 3 SHOWN

Comfort

Upright

Bike

UPRIGHT BIKE ASSEMBLY STEP 3

COMFORT 3 SHOWN

Note: While assembling the SEAT please make sure the

seat is in right position. Tilt up the front of the SEAT

might help you gain a more stable riding experience.