Operating Instructions and Installation Instructions
10
BOLT (M)
SPRING WASHER (N)
FLAT WASHER (K)
WAVY WASHER (L)
PEDAL ARM
CRANK
PEDAL ARM WHEEL
GUIDE RAIL
CONSOLE MAST
PRE-INSTALLED BOLTS
AND WASHERS
CONSOLE CABLES
MAIN FRAME
ASSEMBLY STEP 3
A Open hardware for step 3.
B Carefully pull the console cable through
the console mast using the twist tie located
inside the console mast.
C Attach console mast to main frame
using pre-installed bolts and
washers.
D Slide wavy washer (l) over cranK
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
E Attach the pedal arm to the cranK using 1
flat washer (K), 1 spring washer (n)
and 1 bolt (m).
F Repeat steps D–E on the opposite side of the
elliptical.
BOLT (M)
20 mm
Qty: 2
SPRING WASHER (N)
15 mm
Qty: 2
WAVY WASHER (L)
22.5 mm
Qty: 2
FLAT WASHER (K)
20 mm
Qty: 2
HARDWARE FOR STEP 3:
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
ALL
MODELS
ENDURANCE 5 SHOWN