User's Manual

EN
1514
After Connection
When the transmitter and receiver are turned on and after the receiver connects
to the transmitter and normal control of all channels occurs, if loss of signal
occurs Preset Failsafe drives all servos to their preset failsafe positions. For
sailplanes it’s recommended that the spoilers/flaps deploy to dethermalize the
aircraft, preventing a flyaway. Some modelers prefer to use this failsafe system
to program a slight turn and low throttle to prevent their aircraft from flying away.
When the signal is regained, the system immediately (less than 4 ms) regains
control.
Preset Failsafe
1
Move all sticks and switches on the transmitter to desired Failsafe
position.
2 Push and Hold Bind Button
3 Power on Receiver
4 Release Button after RX goes into Bind Mode (flashing LED)
5
Push and Hold the Bind Button again before the transmitter enters
Bind Mode.
A* Install bind plug (optional)
B* Remove plug once RX goes into Bind Mode
*Setting Failsafe can be done with the Bind Plug if desired.
**Remove Bind Plug when finished setting up Failsafe.
Preset Failsafe
Preset failsafe is ideal for sailplanes, allowing the aircraft to automatically
dethermalize if the signal is lost. With preset failsafe, all channels go to their
preset failsafe positions if the signal is lost, preventing a flyaway. When the
receiver detects signal from the transmitter, normal aircraft operation resumes.