User's Manual

2
EN
TRANSMITTER CONTROLS
Power Switch
Poweronoroffthetransmitter
Reverse Switch
Allowsyoutochangethedirectionofsteering
(ST.REV)andthrottle(TH.REV)controls(Ensure
properfunctionwitharadiosystemtest)
Throttle Trigger
Controlspower
tothemotorfor
forwardorreverse
Steering Wheel
Controlsteering.Right
andLeftsteering
Failsafepositionsaresetduringbinding.Intheunlikelyeventthattheradiolinkislostduringuse,thereceiverwillholdthesteeringatthelast
commandwithnothrottle.Ifthereceiverispoweredonbeforepoweringonthetransmitter,thereceiverwillenterfailsafemode.Whenthetransmitter
ispoweredon,normalcontrolisresumed.
BINDING
FAILSAFE
SolidRedandGreen:Battery
voltageisgood(above4V)
SolidRed:Batteryvoltage
iscriticallylow(below4V).
Replacetransmitterbatteries
Battery Level Indicator
Steering Rate
Adjuststheamountthe
frontwheelsmovewhenthe
steeringwheelisturnedleft
orright
Throttle Dual Rate
Adjuststhemaximumamount
throttlethevehiclecanbe
given
Adjuststheneutralpointofthe
electronicspeedcontrol
Throttle Trim
Adjusttomakethevehicle
drivestraightwithnoinputat
thesteeringwheel
Steering Trim
Stop ReverseForward
BindingistheprocessofprogrammingthereceivertorecognizetheGUID
(GloballyUniqueIdentier)codeofasinglespecictransmitter.
1. PoweroffthetransmitterandESC.
2. ConnectafullychargedbatterypacktotheESC.
3. PressandholdthebindbuttonwhilepoweringuptheESC.After2
secondstheESCwillbeinbindmode.
4. Releasethebindbuttonandpowerontransmitter.
5. BindingiscompletewhenyouhearthreebeepsfromtheESC.
Youmustrebindwhenbindingthereceivertoadifferenttransmitter.
NOTICE:Donotattempttobindthetransmitterandreceiverifthereare
othercompatibletransmittersinbindmodewithin400feet.Doingso
mayresultinunexpectedbinding.