User's Manual

Note:

As long as the "key" switch remains pressed, the radio code is transmitted,

but for a maximum of 15 seconds.

After the first transmission a phase of 20 seconds is started, in which the

same radio code can be repeatedly transmitted using any key, except the

"bell/light" key (in doing so, rapid signal tones sound). The end of this

phase is signalled by a long signal tone.

With the "bell/light" key, the phase of 20 seconds can be prematurely ter-

minated (in doing so, a long signal tone sounds). In this way it is possible

to enter another access code without having to wait for the 20 seconds

to expire and to thus transmit another radio code in order to use it, for

example, to open or close another door.

5.2.2 Learning after entering an access code

Attention!

During the learning process, a door cycle can be initiated by activating

the teaching transmitter, provided a receiver programmed for it is located

nearby!

1. Enter the valid access code using the numeric keys.

2. Hold the teaching transmitter near to the FCT-10 (with 390 MHz: next to

numeric key „3“) and then press and keep pressed the desired key of

which the radio code is to be learned (see figure 2).

3. Press the "key" switch and keep it pressed ➜ if a valid entry has been

made, a long signal tone sounds.

4. If the received signal from the teaching transmitter is strong enough, after

approx. 0.5 seconds brief signal tones are emitted for about 4 seconds

indicating that the signal can be learned.

5. Keep the keys pressed right up until the end of these 4 seconds ➜ after

HÖR/Funkcodetaster FCT10/4Spr. 18.12.2001 14:19 Uhr Seite 11