User's Manual

12
successfully entering the access code, a long signal tone sounds.
6. Release the keys of the teaching transmitter and the FCT 10.
7. Carry out a function test, if this is unsuccessful, repeat the operation.
Note:
If the "key" switch is released before the 4 seconds mentioned above
have elapsed, the learning process is aborted, signalled by three brief
signal tones. The existing radio code is then retained.
5.2.3 Recoding a radio code location with an access code or
resetting this radio code location to the factory coding
1. Enter the valid access code using the numeric keys.
2. Press the "key" switch and keep it pressed ➜ if a valid entry has been
made, a long signal tone sounds.
3. Immediately afterwards press the "bell/light" key in addition and keep
it pressed ➜ brief signal tones start to be issued for approx. 4 seconds
indicating that the unit can be recoded or reset to the factory coding.
• If one of the two keys is released before the end of these 4
seconds, the existing radio code is overwritten by a new unique
radio code ➜ after successfully recoding, a long signal tone sounds.
• If the two keys continue to be pressed until the end of the 4
seconds, the existing radio code is reset to the factory coding ➜
after successfully resetting to the factory code, a long signal tone
sounds.
4. Release the keys.
Note:
If both keys are released before the end of the above-mentioned 4
seconds, the recoding or resetting process is terminated, in connection
with which three brief signal tones sound. The existing radio code is then
retained.
HÖR/Funkcodetaster FCT10/4Spr. 18.12.2001 14:19 Uhr Seite 12