User's Manual

13
5.3 Direct function of the "bell/light" key
During normal operation the "bell/light" key has a special status – it can be
used directly just like a hand transmitter for transmitting and learning, i.e.
without having to enter an access code. Furthermore, its radio code can
be recoded as well as reset to the factory coding.
Within the operating functions this direct function is nearly always active, i.e.
even when an access code is being entered, provided no other key is
being pressed or in another radio code location no transmission, learning re-
coding or factory coding is taking place.
An exception is the phase of 20 seconds in which the same radio code can
be repeatedly transmitted, without a new access code having to be entered,
as in doing so the "bell"light" key for prematurely terminating this phase is re-
quired. During these 20 seconds the direct function of the "bell/light" key is
therefore deactivated.
5.3.1 Transmitting using the "bell/light" key
1. Press the "bell/light" key ➜ a long signal tone sounds and the radio code
belonging to it is transmitted (in doing so, rapid signal tones sound).
Note:
As long as the "bell/light" key continues to be pressed, the radio code is
transmitted, but for a maximum of 15 seconds.
5.3.2 Learning using the "bell/light" key
Attention!
During the learning process, a door cycle can be initiated by activating
the teaching transmitter, provided a receiver programmed for it is located
nearby!
1. Hold the teaching transmitter near to the FCT 10 (with 390 MHz: next to
numeric key „3“) then press and keep pressed the desired key of which
HÖR/Funkcodetaster FCT10/4Spr. 18.12.2001 14:19 Uhr Seite 13