User's Manual

14
the radio code is to be learned (see figure 2).
2. Press the "bell/light" key and keep it pressed ➜ if a valid entry has been
made, a long signal tone sounds.
3. If the received signal from the teaching transmitter is strong enough, after
approx. 0.5 seconds brief signal tones are emitted for about 4 seconds
indicating that the signal can be learned.
4. Keep the keys pressed right up until the end of these 4 seconds ➜ after
successfully entering the access code, a long signal tone sounds.
5. Release the keys of the teaching transmitter and of the FCT 10.
6. Carry out a function test, if this is unsuccessful, repeat the operation.
Note:
If the "bell/light" switch is released before the 4 seconds mentioned
above have elapsed, the learning process is aborted, signalled by three
brief signal tones. The existing radio code is then retained.
5.3.3 Recoding the radio code location of the "bell/light" key or
resetting this radio code location to the factory coding
1. Press the "bell/light" key and keep it pressed ➜ a long signal tone sounds.
2. Immediately afterwards press the "key" switch in addition and keep it
pressed ➜ brief signal tones start to be emitted for approx. 4 seconds
indicating that it is possible to recode or to reset to the factory coding.
• If one of the two keys is released before the end of these 4
seconds, the existing radio code is then overwritten by a new
unique radio code ➜ after successfully recoding, a long signal
tone sounds.
• If the two keys continue to be pressed right up until the end
of the 4 seconds, the existing radio code is reset to the factory
coding ➜ after successfully resetting to the factory setting, a long
signal tone sounds.
3. Release the keys.
HÖR/Funkcodetaster FCT10/4Spr. 18.12.2001 14:19 Uhr Seite 14