Instruction Manual

Changing Primer Components

When changing from a large primer to a small primer (or vice

versa), you need to change the Primer Feed Tube Primer Slide

and Punch Assembly.

If there are primers in the Primer Feed Tube, you will need to

empty it before changing the tubes. If the Primer Feed Tube is

already empty, skip to next step.

Remove the Cap Screw, cup your hand under the Primer Tube

and rotate the Primer Feed Body Assembly clockwise to catch

the primers. After the tube is empty, rotate the body back in

place and re-install the mounting screw.

Disconnect the Spring from the roller pin and remove the

Primer Slide. Remove the Primer Tube Support and the Primer

Feed Tube.

Fill the primer tube as described in the Operations Section.

The Primer Seater Punches are installed from the bottom side

of the Sub-Plate. Raise the Ram to the top of the stroke. Use

a wrench to loosen the Primer Seater Punch and unscrew

it from the Sub-Plate. When installing a new Primer Seater

Punch, tighten it snug with a wrench. Do not over tighten the

Primer Punch.

Primer Feed

Tube

Primer Seater

Punch

Primer Slide

Spring

Punch Assembly

- 20 -

CHANGE-OVER: AP PRESS

CHANGE-OVER