Instruction Manual

Installing the Primer Tube Housing
Slip the threaded end of the Primer Tube Housing (6) over
the Primer tube and onto the Primer Body.
Screw the Primer Tube Housing on to the Primer Body (14)
clockwise: tighten very lightly. Lower the handle.
Primer Tube Support installation
Place the Primer Tube Support (1) over the Primer Feed
Tube and slip the three tapered “fingers” inside the Primer
Tube Housing. This will create a recess that allows the
Primer Filler Tube to properly align with the Primer Feed
tube during refillings.
Assembly of the Lock-N-Load
®
AP Press is now complete. Please proceed to the Powder Measure
assembly section on the next page.
10
11
10
11
Primer Tube
Housing
Primer Tube
Support
ASSEMBLY
- 9 -
ASSEMBLY: AP PRESS