Instruction Manual

ManualsBrandsHornBlasters ManualsCarNathan 500 Series Horn Kit

Nathan AirChime Installation Manual

Nathan P3, P5, K3LA, K5LA 540 Kit

WARNING: To ensure the longevity of your

system. reading and following these instruc-

tions are recommended. Make sure to change

lters and to drain the moisture from your

tank on a regular basis.

Summary of content (9 pages)

PAGE 1
Nathan AirChime Installation Manual Nathan P3, P5, K3LA, K5LA 540 Kit WARNING: To ensure the longevity of your system. reading and following these instructions are recommended. Make sure to change filters and to drain the moisture from your tank on a regular basis.
PAGE 2
HornBlasters Nathan AirChime Installation Guide Support Line: +1 (813) 783-8058 Fax Line: +1 (813) 783-2407 support@hornblasters.com www.hornblasters.com Before Getting Started Read over the entire instruction guide before you begin your installation.
PAGE 3
Safety During Installation • Disconnect the ground of your battery before beginning your installation. • Use eye protection when operating drills. • Take your time and do not rush your installation. Installing Your Train Horn Kit Planning Your Installation This is the most important step in your installation. • Plan out the location of each component before starting your installation. • Make sure you have enough airline and wire to install the system before beginning the installation.
PAGE 4
II. Installing Your Air Compressor Pump Locate a flat and secure installation area that will remain free of dust, dirt, and debris (your compressors performance is directly affected by air quality). Try to keep the distance of the unit from the battery to a minimum to keep your compressor running at maximum performance. 1. Disconnect the ground cable from the vehicle’s battery. 2. Position the unit in the desired location and secure it using the supplied mounting hardware (8mm). 3.
PAGE 5
Drain Cock to Tank: 1. Install the drain cock into the 1/2” port on the bottom of the tank using the 1/2” to 1/4” NPT F bushing. If the drain cock already has sealant on its threads it is unnecessary to use Teflon tape on the threads. Pressure Switch in to Tank: 1. Install the pressure switch into an available 1/2” port on the air tank using Teflon tape or pipe sealant on the threading of the 1/2” to 1/4” NPT F bushing.
PAGE 6
Maintenance & Tips Disconnect electrical components and drain you air system before performing maintenance. General Air Horn System Maintenance • Check your air horns for debris when appropriate and at least once a month and clean when necessary. • Drain your air system at least every other week, to remove any condensation buildup on the inside of your air tank. • Make sure your air compressor is clean and free from debris at all times. • Periodically change your two stage air ﬁlter on your compressor.
PAGE 7
Photograph & Media Submission Guidelines Send in your installation photographs and any other media for a chance to be featured on our web site! General Photograph Submission Guidelines • Please submit clean, concise photographs. Make sure your subject is clearly visible and in focus. • You may submit and digital image format either via email at media@hornblasters.com, or via digital media (CD, DVD, etc). • Make sure to include some kind of personal information with your submission.
PAGE 8
PAGE 9