Owner manual

ManualsBrandsHornBlasters ManualsFor the carPA-100H

P.A. System Installation Manual

100 Watt Public Address w/ Sirens

WARNING: To ensure the longevity of your

system, reading and following these instruc-

tions are recommended. Make sure to change

lters and to drain the moisture from your

tank on a regular basis.

Summary of content (8 pages)

PAGE 1
P.A. System Installation Manual 100 Watt Public Address w/ Sirens WARNING: To ensure the longevity of your system, reading and following these instructions are recommended. Make sure to change filters and to drain the moisture from your tank on a regular basis.
PAGE 2
HornBlasters Public Address System Installation Guide Support Line: +1 (813) 783-8058 Fax Line: +1 (813) 783-2407 support@hornblasters.com www.hornblasters.com Before Getting Started Read over the entire instruction guide before you begin your installation. Kit Contents: • HornBlasters PA Control unit with microphone • HornBlasters PA speaker • Wiring Kit IMPORTANT: This complete public address system uses 12 volt DC components. Only install this kit with a 12 volt DC power source.
PAGE 3
Installing Your Public Address System The HornBlasters PA-100H can be installed in many different types of vehicles. The guidelines for the installation of the product are written so that no matter what vehicle is being used, the installation and operation will be simple and straight forward. Selecting A Mounting Location The following guidelines will help you select a good location. A) The unit should be mounted on a metal surface to aid heat dissipation.
PAGE 4
Wiring Diagram Important Disconnect the ground (Negative -) terminal from your battery until you are ﬁnished making all electrical connections. • The control harness in the diagram is a representation of the harness at the back of the ampliﬁer. • As shown in the legend, the thick (bolded) lines are ones required to use the public address/siren functions of the unit. • The thinner lines, marked in the legend as optional connections, may be used to wire up accessories.
PAGE 5
Close Up on the Control Harness The control harness comes pre-wired with the required wires to use the public address (bolded in diagram). To aid in understanding the layout it is as follows: (use the red/black wires to determine orientation).
PAGE 6
Finishing Up Once you have finished your installation, make sure the gain of your amplifier us turned to the ‘off’ position, the accessory switches are in the off (0) positions, fuses are inserted into any fuse block you installed, and finally to reconnect the ground terminal of your battery. Testing Your Installation Before using your public address and siren system, you should test the work you’ve done. 1. Make sure every electrical connection is solid and that there are no loose wires.
PAGE 7
Maintenance & Tips General Public Address System Maintenance • Make sure all wired connections are secure and making good contact. • Periodically check to make sure that your speaker is free from dirt and debris. Tips • Make sure your engine is running when your public address is in use to insure proper voltage proper Troubleshooting Problem Possible Cause(s) Public address system does not turn on when gain is turned up. (Light should light up on control panel) 1. Fuse is blown.
PAGE 8