Manual

MAN0925-02-EN Specifications / Installation
________________________________________________________________________________________________________________________________________
6/1/11 Page 4 of 5 # 1018
4.2 Ethernet Port
Table 3 - Ethernet Port
Speeds
10 BaseT Ethernet (10-Mbps)
100 BaseTx Fast Ethernet (100-Mbps)
Modes
Half or Full Duplex
Auto - Negotiation
Both 10/100-Mbps and Half/Full Duplex
Connector Type
Shielded RJ-45
Cable Type (Recommended)
CAT5 (or better) UTP
Port
Auto MDI/MDI-X
4.3 External DIP Switch settings
4.4 CAN Network Port and wiring 4.5 Power port and wiring
Table 2 - Ports and Functions
Functions
Port 1 (MJ1)
Port 2 (MJ2)
RS-232
!
!
Hardware Handshaking
!
X
Programming
!
X
Ladder function controlled
!
!
Serial Downloadable
Protocols
!
!
RS 485 Half duplex
!
!
RS485 Full duplex
X
!
NET 1 Port Pin Assignments
Pin
Signal
Signal Description
Direction
1
V-
CAN Ground
-
2
CN_L
CAN Data Low
In/Out
3
SHLD
Shield Ground
-
4
CN_H
CAN Data High
In/Out
5
NC
No Connect
-
Primary Power Port Pins
Pin
Signal
Description
1
Ground
Frame Ground
2
V-
Input Power Supply Ground
3
V+
Input Power Supply Voltage
As seen when looking at the side of the RX371 unit:
The DIP Switches are used for
termination of the RS-485 ports. The
RX371 is shipped un-terminated.
To terminate, select one of the DIP
Switches and configure it based
upon the option that is desired.
MJ1
On
Off
On
Off
On
Off
MJ2
SW1 –
ON enables MJ2 RS485 port termination (121 ohms)
OFF disables MJ2 RS485 port termination.
SW2 & SW3 –
ON places MJ2 RS485 port in half-duplex mode.
OFF places MJ2 RS485 port in full-duplex mode.
SW4 –
ON enables MJ1 RS485 port termination (121 ohms)
OFF disables MJ1 RS485 port termination.
CAN Connector
Use the CAN Connector when
using CsCAN network.
Torque rating 4.5 – 7 Lb-In
(0.50 – 0.78 N-m)
Power Connector
Power Up:
Connect to Earth Ground.
Apply 10 - 30 VDC.
Screen lights up.
Torque rating 4.5 – 7 Lb-In
(0.50 – 0.78 N-m)