Manual

CH. 13 MAN0924-01-EN
February 8, 2010 Page 84 of 124 # 1018
If communications are successful, the target indicator should show the mode of the controller Target:
yy(R) as shown in the status section above
Cscape Status Bar. (13.2)
If the controller is not communicating you may need to set the target ID of the controller in Cscape or on
the unit. The Target ID allows directing communications to a particular unit when multiple units are
connected via a CsCAN network. Units without CsCAN network ports respond to any network ID and do
not
require the ID to be configured.
To check or change the ID on the RX-371 OCS, press the system menu key.
The first item in the menu is Set Network ID. Pressing Enter allows you to view or modify the ID of the
unit.