Manual

MAN0453-04 10 NOV 2006 PAGE 5
DAC106
Information is subject to change without notice. SmartStack is a trademark of Horner APG, LLC.
6 INSTALLATION / SAFETY
Warning: Remove power from the OCS controller, CAN port, and any peripheral equipment
connected to this local system before adding or replacing this or any module.
a) All applicable codes and standards are to be followed in the installation of this product.
b) Shielded, twisted-pair wiring should be used for best performance.
c) Shields may be terminated at the module terminal strip.
d) In severe applications, shields should be tied directly to the ground block within the panel.
e) Use the following wire type or equivalent:
Belden 8761 or equivalent.
For detailed installation and a handy checklist
that covers panel box layout requirements and minimum
clearances, refer to the hardware manual of the controller you are using. (See the Additional References
section in this document.).
When found on the product, the following symbols specify:
WARNING: To avoid the risk of electric shock or burns, always connect the safety (or earth)
ground before making any other connections.
WARNING: To reduce the risk of fire, electrical shock, or physical injury it is strongly
recommended to fuse the voltage measurement inputs. Be sure to locate fuses as close to the
source as possible.
WARNING: Replace fuse with the same type and rating to provide protection against risk of fire
and shock hazards.
WARNING: In the event of repeated failure, do not replace the fuse again as a repeated failure
indicates a defective condition that will not clear by replacing the fuse.
WARNING: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, or service this
equipment. Read and understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in severe bodily injury or loss
of life.
Warning: Consult user documentation.
Warning: Electrical Shock Hazard.