Owner manual

MAN0577-03-en
Page 20 of 98
EO 09-0009
DeviceNet Modules
HE800DNM650 & HE800DNS600
•
Create a new project
File > New > DeviceNet
•
Choose DeviceNet Master (*1) and provide MAC ID
address
Insert > Master
•
Choose Horner DeviceNet device (Slave) and
provide Mac address
Insert > Device
•
Assign the input and output modules (*2)
Mark the Device (left Mouse click), then
Settings > Device Configuration
•
Set device assignment if no automatic assignment
has occurred
Mark the Device (left Mouse click), then
Settings > Device Assignment
•
Save project
File > Save
•
Download Mark the Slave (left Mouse click), then
Online > Download
•
Device diagnostic Mark the Slave (left Mouse click), then
Online > Device Diagnostic
•
Transfer user data:
Write output, read input
Mark the Device (left Mouse click), then
Online > I/O Monitor
Table 5: Steps to configure a DNS600 with any DeviceNet Master.
Note (*1): Insert a Horner SmartStack DeviceNet Master (HE800DNM650). This Master is a place holder
and it is not necessary to match the connected Master.
Note (*2): The Offset addresses assigned in the Slave configuration are always related to the DeviceNet
Master.