Installation Guide

Fitting the C-Stat Programmable Room Thermostat

Before final installation it is advisable to commission the product

and ensure that the Thermostat and Receiver are

communicating satisfactorily. First install the 2 x AA batteries

provided making sure that they are fitted correctly as indicated

by the markings in the battery compartment on the front of the C-

Stat. Once the thermostat and receiver are successfully 'paired'

the thermostat can be installed in its correct location. Please see

Z-Wave pairing instructions on page 9.

Avoid installing the C-Stat against or behind any large metal

surfaces which could interfere with the radio signals to and from

the ASR-ZW receiver. The C-Stat should be mounted on an

internal wall approximately 1.5 metres from floor level using the

wall plate provided and should be in a position away from

draughts, direct heat and sunlight. Ensure that there will be

enough space to allow easy access to the two retaining screws

located at the base of the wall plate.

1.5m