User's Manual

ATM300
[ User manual ]
1) Sub Board :
The sub board will supply the power to module and it will be used for parameter setting (PPS) and
data receiving and sending by PC. If you apply the DC 4-10V to power terminal, then module
will be activated.
The communication with PC will be able to by specific data link cable which supplied by module
supplier.
< Figure 5 > Data Link Cable
2) Data Link Cable :
It will be used for communication between ReFLEX Module and PC through Sub Board. The data
link cable, which is being supplied by ATM300 supplier, incorporated the RS232C converter, then
you can communicate with PC without additional peripherals.
Tel 02 ) 2659 - 7345
Fax 02 ) 3662 - 0973
http://www.hstelnet.com/
Tel 02 ) 2659 - 7345
Fax 02 ) 3662 - 0973
http://www.hstelnet.com/
ReFLEX Module
5/13
ReFLEX Module