KEYPAD User Manual
1) Sensor(Remote Controller) registration ① To add a sensor, you need to press the Reset Button behind of Smart Hub which could make the registration-mode is on. Th en, the Smart Hub beeps, and the color of a LED light of Smart Hub turns into Blue Flashing. The Registration mode is only vali d within 1 minute. ② Open the cover of a sensor, and input the batteries included in the sensor package box to complete its registration.
2) Password registration In the sensor list page from RayHome application, user shall choose the selected Remote Controller device and then type in new 6 digit password for registration.
3) Delete Password In the sensor list page from RayHome application, user shall choose the selected Remote Controller device to go into the setting, and then select the Remote Controller device to delete the passcode. 4)-1 ARM Press registered 6 digit passcode and then press LOCK button to ARM setting up. 4)-2 DISARM Press registered 6 digit passcode and then UNLOCK button to DISARM setting up.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Information to User This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
