Ice Maker User Manual

D. Setup

1) Position the icemaker in the selected permanent location.

2) Level the icemaker from side-to-side and front-to-rear by adjusting the feet.

E. Electrical Connection

WARNING

1. Electrical connection must meet national, state, and local electrical code

requirements. Failure to meet these code requirements could result in death,

electric shock, serious injury, re, or severe damage to equipment.

2. This unit requires an independent power supply. See the nameplate for

proper voltage and breaker/fuse size. Failure to use a proper breaker or fuse

can result in a tripped breaker, blown fuse, or damage to existing wiring. This

could lead to heat generation or re.

3. THIS UNIT MUST BE GROUNDED:

This unit is equipped with a 3-prong

grounding plug to reduce the risk of potential shock hazards. It must be

plugged into a properly grounded, independent wall outlet. If the outlet is a

2-prong outlet, it is your personal responsibility to have a qualied electrician

replace it with a properly grounded, independent 3-prong wall outlet. Do not

remove the ground prong from the power cord and do not use an adapter

plug. Failure to follow these instructions may result in death, electric shock, or

re.

4. Do not use an extension cord.

5.Makesurethecontrolswitchisinthe"OFF"positionbeforeplugginginor

unplugging the unit to reduce the risk of electric shock.

6. Do not use a unit with a damaged power cord. The power cord should not be

altered, jerked, bundled, weighed down, pinched, or tangled. Such actions

could result in electric shock or re. To unplug the unit, be sure to pull the

plug, not the cord, and do not jerk the cord.

7. To reduce the risk of electric shock, do not touch the plug or control switch

with damp hands.

8. The GREEN ground wire in the factory-installed power cord is connected

to a screw on the rear panel where the cord enters the unit. If it becomes

necessary to remove or replace the power cord, be sure to connect the

power cord's ground wire to this screw upon reattachment.

•Usuallyanelectricalpermitandservicesofalicensedelectricianarerequired.

•Themaximumallowablevoltagevariationis±10percentofthenameplaterating.

•Foroptionaldrainpumpinstallation,refertotheinstructionmanualincludedwiththe

pump.