Instruction Manual

Electronic Control

After connecting your unit, move the power switch located next to the controller to the

“ON” position. The display will show the cabinet temperature. Also, the compressor and

fan icons will flash for a period of three minutes. After this delay the unit will start

cooling.

Verify you don't have any alarms on the controller. If after you turn ON the equipment

the controller shows an alarm icon or an error code, please contact your local Hoshizaki

certified service representative. They will help you fix the problem.

2.3 Machine settings and programs

Changing the temperature set point on the controller.

The unit comes with a factory default setpoint of 32°F. If set point needs to be changed,

follow the steps below.

Press and hold the SET button for one second. You should see a flashing number.

Release the button.

Press the up and down arrows to increase or decrease the setpoint. Then press the

SET button to save the new setpoint.

Note:

The maximum value you can set in the controller is: 36°F

If you wish to decrease the setpoint, press the DOWN arrow button until you reach the

desired value. Release the button and then press the SET button to keep, and save, the

new value.

Note:

The minimum value you can set in the controller is: 30°F

FIGURE 1

In Set mode, press to raise temperature set point.

Otherwise, press to turn appliance on or off

without unplugging or using power switch

Compressor Icon

Cabinet Temperature

Press to change the temperature

set point and access the

programming mode.

In Set mode, press to lower

temperature set point. Otherwise,

press to initiate manual defrost.